MK 1700A
14 CHANNEL FAMILYRADIO SYSTEM
CALL
ENTER
MENU
MIC
BEFORE OPERATING THIS PRODUCT
PLEASE READ THESE INSTRUCTIONS
COMPLETELY
FCC WARNINGS
This device complies with part 15 of the FCC rules, operation is
subject to the condition that this device does not cause harmful
interference.
Features
No Air Time Fees and No License Required
Up to 2 miles range
14 Channel
Build-in VOX Function(Optional)
Muti-function LED Display
Talk Confirmation Tone and Call / Ring Button
Auto Battery Saver and Auto Squelch
Monitor and Key Lock Button
External Power (DC 6V) and External Microphone Speaker Jacks
Detachable Belt Clip
PRECAUTIONS
• Do not modify or attempt to adjust the transceiver for any reason.
• Avoid extremes in exposure to water, heat, and cold. This
transceiver is weather resistant but not waterproof.
• Do not expose the transceiver to long period of direct sunlight,
nor place the transceiver close to heating appliances.
• Do not place the transceiver in excessively dusty areas, humid
areas, wet areas, nor on unstable surfaces.
• If an abnormal or smoke is detected coming from the trans-
ceiver, immediately switch OFF the power and remove the bat-
teries from the transceiver. Contact your dealer.
UNPACKING
Carefully unpack the transceiver. We recommend that you iden-
tify the items listed below before discarding the packing material.
• Transceiver ..........................1
• Belt Clip ..............................1
• Instruction Manual ...............1
1
Controls and Indicators
1. Earphone/Microphone jack
2. Transmission/Reception indicator
3. PTT button
4. MONITOR button
5. ENTER/LOCK button
6. UP/DOWN buttons
7. Microphone
1
8. POWER button
9. MENU button
10. CALL button
11. Power Saver mode
indicator
2
3
13
12
11
10
9
12. LED display
13. Ext. Power IN
CALL
ENTER
MENU
4
5
6
7
MIC
8
Display and Indicators
LED display - indicates Channel numbers, Volume level, Lock,
Beep, Low Battery Level, etc.
Transmission and Receiption indicator - When transmitting,
the indicator stays on. The indicator flashes when receiving a
singal.
Power Saver Mode indicator - flashes in Power Saver Mode.
2
Operation
Install Batteries
1. Pull lock tab down and lift door up (towards you) to remove
battery cover.
2. Insert four
batteries. Position batteries according to
polarity markings.
Note : When batteries are low or need charging the BATTERY
LOW “L” will blink. Replace all batteries with new alka-
line batteries.
Download from Www.Somanuals.co3m. All Manuals Search And Download.
To Turn On The Unit or To Turn Off The Unit
Press the POWER switch for more than 1 second.
Auto Battery Power Saver
The unit has a special circuit designed to extend battery life. If
there are no transmissions within 5 seconds, the unit will auto-
matically switch to battery save mode. The Power Saver Mode
LED(Green) will flash.
Low Battery Indicator
When battery level becomes low, “L” appears on the LED dis-
play and flashes. Replace all four batteries with new ones.
To Transmit
Simply talk to the built-in microphone as VOX (Voice Activated
Transmission) turns into transmission mode automatically, or
press the PTT(Push-To-Talk) button.
To Adjust VOLUME control
Press momentarily UP button to increase or DOWN button to
decrease volume.
The higher number, the higher volume level.
To Select Channel
1. Press the MENU button. The LED display indicates a flashing
number.
2. Press the UP or DOWN button to set a desired channel from 1
to 14.
3. Press the MENU button to continue other settings.(Beep On or Off).
To complete setting, press the ENTER button.
Download from Www.Somanuals.com4. All Manuals Search And Download.
|